Loading.

. Location setup: select your country and time zone.
    • Format: +/-hh:mm
    . Off peak charging.
    According to local regulations, by default, the EVCS must be configured to NOT charge between 8 AM - 11 AM, and 4 PM - 10 PM on weekdays (OFF-peak charging). You can deactivate it now or at any time after the 'First setup' procedure.
    . WiFi setup: configure your WiFi network.
    №SSIDPasswordUseDelete
    . Access setup: assign your username and password or leave the default one.
          . Charging current setup: set the maximum charging current for your device.
          . Saving settings
          A
          Grid

          L1:
          L2:
          L3:
          Inverter / Charger

          Absorption

          AC loads

          L1:
          L2:
          L3:
          Solar yield

          Battery

          EVCS

          Charging
          Manual
          0:0
          Session cost
          Session saved cost
          Total energy
          0.0 W
          Connected
          Session time
          Session energy
          Session cost
          Session saved cost
          Total energy
          Backup & Reset
          Uploading firmware. Do not turn off the power...
          0%
          Firmware successfully updated. Wait for the system reboot...
          The FW update procedure is in progress now. Please wait...
          Upgrading firmware. Do not turn off the power...
          0%
          The FW update procedure is in progress now. Please wait...
          Firmware successfully updated. Wait for the system reboot...
          Access
                Bluetooth
                Charger
                • Renault Zoe - 10A
                • Coefficients equal to 1.0 leave the actual power value unchanged
                • Coefficients greater than 1.0 increase the actual power value
                • Coefficients less than 1.0 decrease the actual power value
                Date & Time
                  • Format: +/-hh:mm
                  The date and time will be lost if a system power-down happens.
                  Display
                  Ethernet
                  GX device
                  • only if 'Allow battery/grid power for auto mode' activated
                  NOTE: If you have enabled this feature, be sure that you added the correct IP address of the GX device to the 'GX IP address' above or to the 'whitelist table' below. Otherwise, the GX device will not communicate with EVCS!
                  №IP addressDelete
                  Light Ring
                  Disconnected
                  Connected
                  Waiting for start
                  Waiting for RFID
                  Waiting for sun energy
                  Low SoC
                  Charging manual
                  Charging auto
                  Charged
                  Error
                  Limit
                  Others
                  Scheduler
                  Scheduled mode requires local time synchronisation. Make sure the EVCS has an internet connection and the time zone is set correctly (General ->Date & Time).
                  №StatusTimeCurrent(A)SummaryRepeatEnableEditRemove
                  You have unsaved changes!
                  WiFi
                  №SSIDPasswordUseDelete

                  Login

                  Sign In to your account

                  Error: 404

                  Page not found!

                  Error: 503

                  Service Unavailable!